Replacing the G7 EXO Diffusion Cartridge Cover

Due to a temporary supply chain shortage, the G7 EXO Diffusion cartridge cover will be secured to the device using two different M4 screw sizes: 2 × 18 mm screws for the top holes and 2 × 14 mm screws for the bottom holes.

If you remove G7 EXO Diffusion’s cartridge cover, make sure that you re-attach the cover using the correct M4 screw for the location.

You will need:

• Phillips flat head screwdriver

• 2 x 18 mm M4 screws

• 2 x 14 mm M4 screws

To replace the diffusion cartridge cover:

1. Replace the diffusion cartridge cover on G7 EXO, ensuring that you properly orient the cartridge cover over top of the device’s front enclosure.
2. Insert the 18 mm M4 screws into the top threaded holes of the cartridge cover.
3. Insert the 14 mm M4 screws into the bottom threaded holes of the cartridge cover.
4. Tighten the screws using the Phillips flat head screwdriver, ensuring they are snug but not over-tight.

We’re here to help

Let us know if you have any questions — don’t hesitate to reach out to our Customer Care team.