G6

Each G6 single-gas detector comes pre-installed with one of the following gas sensors:

• H₂S
• CO
• O₂
• SO₂

Yes, G6 is certified to be intrinsically safe for use in Class I Division 1 Groups A,B,C,D T4; Ex ia IIC T4 Ga; Class I Zone 0 AEx ia Group IIC T4 Ga hazardous (classified) locations. For more information, see the G6 Technical User Manual.

G6 does not have a cartridge, as the sensor is permanently installed in the device. 

No. Once G6 has been manufactured for a specific target gas, you cannot change to another gas. However, factory-trained personnel can replace the sensor with another sensor of the same type during servicing.

G6 can be bump tested or calibrated manually using a calibration cap, or automatically using G6 Dock.

G6 automatically connects and synchronizes with Blackline Live every 5 minutes to 6 hours, depending on your service plan.

G6 also connects with Blackline Live when a high urgency notification is activated, and while secured in G6 Dock.

Low urgency notifications are used to communicate events that require your attention. A low urgency notification includes yellow flashing lights, sound, vibration (if enabled), and an on-screen message specific to the event.

NOTE: Non-gas related low urgency notification lights, sound, and vibration automatically mute after two minutes. Gas related low urgency notifications repeat until they are acknowledged or resolved.

High urgency notifications communicate events that require your immediate attention and action. A G6 high urgency notification includes red flashing lights, sound, vibration, and an on-screen message specific to the event.